1. Prepare

Protect surfaces not intended to be treated. Ensure that walls, mulch borders and other surfaces are protected as needed.

Ensure proper surface temperature. Ensure ambient air temperature stays above 50°F until product is dry. If temperature falls below 50°F, curing time will increase and the performance of the product may be adversely affected.

A dry surface is necessary to ensure proper product performance. Do not apply if rain is forecasted within 24-hours.

Ensure that the sprayer is clean prior to application.

2. Test

Perform a small test area (at least 2 sq. ft.) using the product to ensure suitability and the desired results prior to full application. Use the same preparation, equipment and conditions expected during the entire application.

3. Apply

Do NOT Dilute or alter the product. Shake the container prior to use as some settling may have occurred.

Apply the number of coats as indicated in the Coverage Chart to your surface.

Misting the product or spraying from a large height, may result in uneven coverage and poor performance. When spraying, use even, broad strokes to ensure uniform coverage. Under-application will not allow the product to perform properly.

Allow sufficient dry times. Dominator XL Mulch Anchor requires air to dry, so we recommend waiting at least 45 minutes to 1 hour between coats.

4. Cleanup

Place any unused product back into original container to store for future use. Any mixture exposed to air will harden in the container. Clean equipment thoroughly until free of product residue using warm water and a mild detergent. Product will stain clothing but can be removed from skin with a mild cleaner. If clothing becomes contaminated, do not allow to dry and wash immediately.

5. Handling & Storage

Store in a cool, dry place. This product can be used after freezing once it has completely thawed.