Installing the new and improved DOMINATOR Polymeric Sand is as easy as Sweep, Activate & Go! We've collected some of the top DOs and DON'Ts to help make your job even easier.
Â
DOs |
Â
DON'Ts |
DO #1Use the Right Tools
|
DON'T #1Don't apply DOMINATOR Polymeric Sand if the paver surface is damp or wet.
|
DO #2Use the "Shower" setting on your hose's spray nozzle |
DON'T #2Don’t Over Water!
|
DO #3Make sure your pavers have proper drainage |
DON'T #3Not for use on constantly wet or submerged surfaces. |
DO #4Use DOMINATOR Polymeric Sand to stabilize paver joints between 1/8" and 4" wide, with a depth of at least 1 ½" |
DON'T #4Don't forget to remove prior paver sand from joints if this is a re-sanding project. |
DO #5Fill the joints up to about 1/8" below the top of pavers (or 3 mm) |
DON'T #5Avoid sweeping the product over long distances, so that its integrity is preserved. |
DO #6Be sure to follow instructions!
|
DON'T #6Don't hesitate to call us for help and advice - 800-270-4050 |
Â
Â
Comments will be approved before showing up.
Tire marks are one of your common questions, as in, "Why do I have tire marks after I sealed my pavers?" To answer this, we need to understand how tire marks occur, on any surface, as well as what our research and development team considers and tests during product development of our sealers. Â