Keep a clean, natural appearance and improve the durability of your concrete driveway, patio pavers, unglazed cement tiles, concrete block retaining wall, cast concrete or your garage floor. AQUA-X 11 protects against mold, mildew, concrete spalling, freeze thaw, pitting, salt damage after sealing with AQUA-X 11 Concrete Sealer.
Breathe easy when applying AQUA-X 11 Concrete Sealer due to no foul odor and low VOCs as so many reviews have noted. Your money goes farther with AQUA-X 11 Concrete Sealer with twice the coverage rate - up to 600 square feet per gallon, and up to 5 years before resealing. Easy one coat application using our included Application Guide and available Application Videos found here.
Don’t spend weekends power washing! Keep your hardscape surface clean after a thorough pressure washing by sealing it with an EASY TO APPLY and LONG LASTING, sealer. Seal your driveway, patio, tiles, retaining wall, or your garage floor with this commercial grade sealer. It protects the surface from the UV rays, mold and mildew and freeze-thaw (and de-icing) damage. AQUA-X sealers creates a moisture barrier and will allow the water to bead on the top rather than penetrating into your surface. After you seal your surface, it makes future maintenance so much easier. Using your garden hose, spend a few minutes lightly hosing off the pollen, mildew, dirt, and any other buildup from the weather. Once sealed, your surface is protected for up to 5 years before having to reseal. Now that is a lot of saved time!
We have many homeowners that call and email each day with this question, so you are not alone! Sealing your surface doesn't have to be a job you contract out. Watch our application videos and read our short homeowner guide so you feel confident in your sealing abilities. Homeowners just like you are raving about this highly effective sealer - easy application. Check out the infographic on the right to see what you will need for this project!
Generally, apply one coat of sealer to surfaces with a sprayer with the appropriate spray pattern for the project. If product puddles or drips on the surface, back-roll to smooth out excess product for even coverage. DO NOT FLOODCOAT. Prior to application, the surface should be completely dry for best results. The surface temperature should be between 30-120° F (-1-49° C), and it should be maintained for 12 hours from the start of application. Do not apply below 40°F (4°C) or above 95°F (35°C). See Technical Data Sheets, our Homeowner Guide and our application videos on our website. Always test using the product to ensure suitability, the desired results prior to full application, and for the application coverage rate. Use the same preparation, equipment and conditions expected during the entire application. Do not let the product freeze; and dispose of properly if it is allowed to freeze. Remove oil and other fluids from the sealed surface as soon as possible using a mild cleaning agent. Please visit the get educated tab for detailed application instructions, Technical and Safety Data Sheets, video demonstrations and other helpful information. Made in the USA.