Your Cart is Empty
FREE and FAST Shipping in the contiguous United States
$79.00
Buy On Amazon Get a Trial Size
Don’t spend weekends power washing! Keep your hardscape surface clean after a thorough pressure washing by sealing it with an EASY TO APPLY and LONG LASTING, sealer. Seal your driveway, patio, tiles, retaining wall, or your garage floor with this commercial grade sealer. It protects the surface from the UV rays, mold and mildew. DOMINATOR sealers is a film forming sealer that will protect your surface. After you seal your surface, it makes future maintenance so much easier. Using your garden hose, spend a few minutes lightly hosing off the pollen, mildew, dirt, and any other buildup from the weather. Once sealed, your surface is protected for up to 5 years before having to reseal. Now that is a lot of saved time!
We have many homeowners that call and email each day with this question, so you are not alone! Sealing your surface doesn't have to be a job you contract out. Watch our application videos and read our short homeowner guide so you feel confident in your sealing abilities. Homeowners just like you are raving about this highly effective sealer - easy application. Check out the infographic on the right to see what you will need for this project!
–The sprayer will help distribute the product more evenly on the surface. Any sprayer will work for our products, although high pressure sprayers will allow higher coverage rates.
–The roller should be used to back-roll any puddles or drips, and to smooth the sealer in textured areas. If you’ve re-sanded the paver joints, ensure that the sand is 1/8” below the top of the paver surface to avoid pulling it up on the roller.
–The extension pole will be used to attach to the roller handle and roller nap. This will allow you to roll onto the surface without bending over.
–The tape will be used to secure the protective paper or plastic on areas that you don't want the sealer to enhance, such as your doors, garage door, garden, etc.
–The protective paper (plastic or paper) will be used to block off the areas where you don't want sealer to be applied.
Do NOT Dilute or alter the product. Shake the PRO TECH SERIES container prior to use as some settling may have occurred. Note that this product prevents water penetration of the surface, resulting in a beading effect. Generally, apply two coats of sealer to brick paver or wood surfaces. Stone and clay brick surfaces typically require only one coat of STONE+. Ensure smooth application of sealer. If spraying, use even, broad strokes to avoid streaking. If rolling, keep a wet edge during application to avoid streaking. If product puddles or drips on the surface, back-roll to smooth out excess product for even coverage. DO NOT FLOODCOAT. The sealer should be absorbed prior to applying subsequent coats. Conditions such as surface porosity, temperature and shade can impact the time needed between coats, in addition to the number of coats necessary to achieve the desired results. Previously sealed surfaces and extremely dense surfaces may only require one coat of sealer. Some extremely porous pavers may require a densifier before application. We recommend a single coat of Paver PreTreat prior to a one coat application on very porous pavers. Reference the “Get Educated” resources on our website for further instructions. The sealer requires air to dry, so wait 45 minutes between coats. If a light rain occurs more than an hour after sealing, then there should not be any issues. The sealer may turn white, but it will dry clear once the moisture escapes.
